• 设为首页
  • 加入收藏
联系我们
联系人:南经理
手机:13932899771 15612833218
电话/传真:0318-8830218
邮箱:706843811@qq.com
地址:河北省冀州市西王工业区
当前位置:首页 >>新闻中心 >> 铸铁方闸门

铸铁方闸门购买后该怎么安装与调试和养护呢?小编根据技术要求总结如下:
How to install, debug and maintain cast iron square gate after purchasing it?
1、 首先铸铁方闸门在安装前,要搜检竖框与横框之间、闸板与闸板之间(指多块闸板组合的闸门)的毗连螺丝,是不是是在运输装卸中激起松动,它们的接茬是不是是错牙,要调剂成一个平面,搜检闸板与闸槽的间隙,保障闸槽与闸板的间隙不大于0.08mm,若有间隙可以调剂闭紧拆卸。上紧各毗连螺栓。
1. Before installation of cast iron square gates, the adjacent screws between vertical and transverse frames, between gates and gates (referring to gates composed of multiple gates) should be searched for, whether they cause loosening during transportation, whether their joints are staggered teeth, and should be adjusted into a plane to check the gap between gates and slots, so as to ensure that the gap between gates and gates is not more than 0.08mm, if there is a gap. Remove tightly by adjusting. Tighten each adjacent bolt.
2、 设备安装时闸门整体竖入预留槽,在单方立框的下面垫上调剂垫(严禁垫下横梁),两立框用手动葫芦和斜拉立稳,将闸门找直找平,各地脚孔内串上地脚螺栓,调剂好闸门的地位,支好模板进行二期浇注。
2. When the equipment is installed, the gate is erected with reserved groove, and the additive pad is raised on the bottom of the single vertical frame (it is strictly forbidden to pad the cross beam). The two vertical frames are stabilized by manual hoist and cable-stayed. The gate is straightened and leveled. Ground foot bolts are strung in the footholes of all places to adjust the position of the gate and support the template for the second-stage pouring.
3、 浇注混凝土时,流进闸板、闸框、斜铁、挡板间的灰浆应完整断根,以防止灰浆凝固后影响闸门启闭。
3. When pouring concrete, the mortar flowing into the gate, the gate frame, the inclined iron and the baffle should be completely broken to prevent the slurry from affecting the gate opening and closing after solidification.
4、 断根加固物。闸门出厂前,为使闸板、闸框贴合紧凑,安装后削减间隙,2m以上的闸门在凹凸框上安装了4-6个紧闭拆卸压铁,正视在间隙调剂后,闭紧压铁裁撤,以便闸门启闭。
4. Root-breaking reinforcement. Before the gate leaves the factory, in order to make the gate plate and the gate frame close and compact, and to reduce the gap after installation, 4-6 closed and disassembled pressing iron are installed on the concave-convex frame of the gate over 2m. Face up to the fact that after the gap adjustment, the closed pressing iron is removed so as to open and close the gate.

关键字:铸铁方闸门
版权所有 © 河北省衡水市博宇水工机械厂
联系人:南经理 手机:13932899771 15612833218 电话/传真:0318-8830218 邮箱:706843811@qq.com 地址:河北省冀州市西王工业区
水利机械推荐:启闭机、螺杆启闭机,卷扬启闭机、启闭机闸门、铸铁闸门、钢制闸门、清污机、拦污栅、橡胶止水等 网址:www.qibiji58.com
友链:光纤激光切割机 抹灰机 螺杆启闭机 过电压保护器 隔离墩模具 蠕动泵 启闭机 电缆挂钩 铸铁闸门 精密铸造 光纤激光切割机 造型机 网站建设及优化:保定遨游公司